Straightforward use

• 

  Parameters configuration

  The (optional, one time) first step is to configure parameters of the Path adjust plugin: set the offset between the mill and the helper laser crosshair.
• 

  Position lower-left corner of the material

  Load the file you want to process. Go over the real lower-left corner of the material. If you're using laser crosshair, then point the center of the crosshair over lower-left corner of the material. Once you're there, just click the button to remember the position.
• 

  Position lower-right corner of the material

  Now go over the lower-right corner of the material (so typically it will be moving along X axis). When you're at the lower-right corner, click the same button to accept. The plugin will run and will adjust loaded path according the two points you've just set. The path will be translated to the first point specified and will be rotated according to the second point specified.
• 

  Start machine job

  Start the job as normal - the machine will execute the job on modified, adjusted path.